Re check both home positions once you have made any adjustments

The calibration process is covered on the Haas Service site

Push the RECOVER button

Use the precision level vial parallel to the turret for this measurement

On a number line, our Total Indicator Reading is three ten thousandths (0.0003 or 0.0076mm) TlR which puts our spindle sweep measurement in specification

It is also possible that the arm is stuck while gripping a tool that is still clamped in the spindle

Jog the turret to the middle of X axis travel

But keep material removal to a minimum, to get the most life out of your jaws

Press LlST PROGRAM and then select the Memory tab

Below the tool offsets are the work zero offsets

Select program O02020 Spindle Warm up and press SELECT PROGRAM

The tool change arm will rotate in reverse and put the tools back into the carousel and spindle

When the coolant tank is full, run each part of the coolant system to check that none of the connections are leaking

Why do you believe in me so much?

You didn't mean to kill Hap any more than I meant to kill Kay.

However, rapid axis movement is automatically limited to 25 of maximum and the command spindle speed in your program may not exceed 750rpm

Twistoid

Bye Go away

I am sick of the sight of you! See you.

See you, bastards!

Go on.

I don't have to exit this screen to change an offset

Using the older software, this is what we do if the arm is not contacting the tool

I'm leaving.

Outta my way

It's not I'm not in the mood !

Patriot Act, Patriot Act.

Got a minute?

I'll see you later.

See you later!

Ok.

But I'll be sure to add more.

See you soon.

And I love you, and I'll always be with you.

And that's what we're going to do in the next video.

I have to go now. I'll be late.

I will continue this in the next video.

So I will continue part b in the next video.

So I will save that for the next video.

Then, I'll go off first.

What is this?

See you!

Bye, Lizzy!

Okay. Okay, bye.

See you guys.