I work as a theoretical physicist.

The approximate diameter, it's a three inch (3 ) shell mill

An amount with which the precision of a measurement can be estimated.

This guy's measuring the water that this leaves in the stream.

Pressure

Measure

When they got better tape measures, they measured hey, my diameter's definitely 1.

Measurements counts

Measurement of an amount of matter.

Readouts are as follows

And when he pulled the trigger, they'll run for the projectile.

A third thing we are looking at and very interested in is simulation.

There is no significant scientific dispute about that.

...you can triangulate his position.

Measurement tool for Impulse Responses

A monitor calibration tool

No Accounting

Readouts are as follows...

These are all forms of energy.

We built engines so we built 100 different engines over the last two years.

So measuring to the nearest millimeter.

In addition to that, we've measured the speed of sound.

And let's say when their tape measures weren't so good,

What would you like to measure? What would you like to analyze?

Volume accounting

Information, too, can be measured and compared using a measurement called 'entropy.'

And then measure the returns, both from a financial perspective and from a social impact perspective.

Let's say that on this circle they measured around it and they found out that the circumference is 6 centimeters, roughly we have a bad tape measure right then.

Again, we wanna minimize the residuals.

(Laughter)

Make a time measurement to check performance

So we have a very sensitive measure of the drag force without any force sensors.

Astronomers use magnitudes which are a logarithmic measure of flux defined by the formula written here.

And finally, what type of probing cycle do I want to use

Crystal structure determination

The font size in pixels.

larger than 90 degrees if you measure it you would have to rotate this ray more to get to this other ray than you would if you had right angles and definitively a lot more if they were acute angles.

But U 6 did not exist before 1994 so, unfortunately, we can't measure U 6 back then.

Uncertainty comes because of noisy observation.

So you could say the measure of angle BAC is equal to 30 degrees.

So let's see how that works.

Flawless precision is required in the measurements.

Even though our business is a little bit steadier than that would seem to imply.

If I were tell you that... Let's say that I were to measure...

Maybe the ratio of the circumference to the diameters always fixed for any circle.