Re check both home positions once you have made any adjustments

Jog the turret to the middle of X axis travel

On a number line, our Total Indicator Reading is three ten thousandths (0.0003 or 0.0076mm) TlR which puts our spindle sweep measurement in specification

When the machine is built, the table is made parallel to the B axis therefore we can use the table surface to set B axis parallel to Y axis

In this video, we will demonstrate the proper way to cut OD gripping soft jaws and cover soft jaw fundamentals The first side of this bearing housing has been completed

The Proper Way to Cut Soft Jaws Part One OD Gripping Fundamentals

The calibration process is covered on the Haas Service site

Push the RECOVER button

Use the precision level vial parallel to the turret for this measurement

So that is my y axis, and this is my x axis.

It's repairable.

So let's graph it.

So I'll just draw this kind of a general graph right here.

Onion

Tamaden?

Guys, listen. Bearing going out. What do you think?

So that's the real part.

Axes

Scales

Axis

Axes

It is also possible that the arm is stuck while gripping a tool that is still clamped in the spindle

Or you could think of them as dimes if we're thinking about change.

But keep material removal to a minimum, to get the most life out of your jaws

Press LlST PROGRAM and then select the Memory tab

Tamasaburo!

Where's Tamaki?

My balls!

Below the tool offsets are the work zero offsets

Select program O02020 Spindle Warm up and press SELECT PROGRAM

All right, there we go.

It's going to look something like that.

You take the Tamaden, which leaves from Shibuya

Vertical Scale

Horizontal Scale

Vertical scale

Horizontal scale

X Axis

Y Axis

Axes labels

x Axis

y Axis

Major Axis

Minor Axis

X Axis