The spindle sweep measurement will show that the spindle axis is perpendicular to the table surface

Attach the Test Indicator to the Magnetic Base

Now we will check roll along the X axis

What about a series of scales, uniform or non uniform? Does order matter?

look at the position of the indicating bubble

If the doors are opened while the machine is running all axis motion will stop and the spindle speed will drop to 750rpm maximum

The reluctant gentleman with the sizeable mouth is mr. Frisby.

At the Control Pendant, press ZERO RETURN and then ALL

So that's my x axis and that is my y axis.

Now we will install the panels which enclose the rear part of the machine

Hold shift or ctrl to move in X axis. Hold shift and control to move in Y axis. Right button click to cancel move.

After adjusting the leveling screw, wait for at least 10 seconds for the bubble to stabilize

Now, let's do it in a different order.

You push on something, and it moves forward.

Now, note the B axis position, in our case it is B0.003

You can push CYCLE START and the machine will run a program but axis motion will be restricted to 25

It's an irregular object oscillating about its own axis

Rotate both middle screws up to bring them completely off the middle pads

And I could do that with an energy diagram.

The period that it takes to go from roughly a 22 angle to a 24,5 angle and back to the 22 angle is 41,000 years.

The B axis home position locates the table face parallel to the X Y plane and the C axis home position locates the table T slots parallel to the X axis

Let's find the equation that shifts the parabola y x² 4x 7 three spaces on the x axis and 2 spaces on the y axis.

Hold shift or ctrl to move in X axis. Hold shift and control to move in Y axis. Right button click to cancel resize.

The first point I go along the horizontal, what we traditionally call our x axis.

We will rough level the machine side to side and front to back

So that is my y axis, and this is my x axis.

Now we will rotate to B90.003 degrees

After an additional reading, we will tilt the front trunnion support to the left or right using the front leveling screws, rotating opposite each other, to align the B and Y axes side to side

Axis width

Let me draw it like this.

You can run any program by pressing and holding the CYCLE START button

So let's graph it.

So I'll just draw this kind of a general graph right here.

Finally what about a series of rotations and translations all along the same axis?

They have lines every 100 units. Each is labeled with the axis that are in that grid plane.

You could make the vertical axis.

Later we will check and adjust the B axis home position

Remove the fasteners holding the spindle head bracket in place

My behavior?

So that's the real part.

Axis line width

Font of the axis labels

Axis line color

Axes

Scales