And finally, what type of probing cycle do I want to use

The approximate diameter, it's a three inch (3 ) shell mill

Can you measure the length?

He measured the length of the bed.

I work as a theoretical physicist.

Pressure

Measure

Use Custom Length

Set Segment Length

Maybe its growth rate slows a little bit.

(Laughter)

Measure the length of the stick with a ruler.

Set the length of the track's post gap

Measurements counts

An amount with which the precision of a measurement can be estimated.

And since they went through the iterations an infinite number of times, as the ruler shrinks down to infinity, the length goes to infinity.

This guy's measuring the water that this leaves in the stream.

Measurement of an amount of matter.

Readouts are as follows

Here you can set the duration of the long break.

I mean, if you actually measure the temperature over a period

Measurement tool for Impulse Responses

A monitor calibration tool

No Accounting

Readouts are as follows...

We can't weigh it, we can't measure it in a laboratory.

Maybe the ratio of the circumference to the diameters always fixed for any circle.

When they got better tape measures, they measured hey, my diameter's definitely 1.

And let's say when their tape measures weren't so good,

But why?

And they want us to use the units of measure.

Triangulate his position.

I'd like to... check your blood pressure.

...you can triangulate his position.

Use my results as a baseline.

In addition to that, we've measured the speed of sound.

So each of these sections are in degrees so we're measuring in degrees, but I want to be clear degrees aren't the only way to measure angles.

If I were to build a fence, if this was like a plot of land,

Volume accounting

I want you to estimate the height of the building.

And we see this in the inexorable march towards standardization.

(Laughter)

Make a time measurement to check performance

It's like this I drew it smaller.

So let me write down M for molar.