Eva Mikulč íková

Eva Brucherseifer

Prepare B pod for EVA, Hal.

Prepare B pod for EVA, Hal.

He's losing his grip.

Attention all hands.

And we'll keep the spindle speed below the recommended 900 rpm

We will address that scenario in another video in this series

This graphic illustrates what would happen if you did not cut to the nominal part diameter

We see a total indicator run out of fifteen thousandths (0.015 , 0.381 mm) at 250 psi

She wanted to dance.

Do not radiate any electrical equipment while EVA is in progress.

Which must be completely profiled on the outside face of the part

We learned about the fundamentals of cutting lathe soft jaws

Now we're ready to make our part To demonstrate how uniformly the pie jaws grip the part

And you can use that now to go for many kilometers horizontally underwater and to depths of 200 meters straight down underwater.

In this video, we will demonstrate the proper way to cut OD gripping soft jaws and cover soft jaw fundamentals

The jaw grippers are now facing outward

Not even where the jaw tips contact the work piece

At 250 psi clamp pressure, our part's total indicated run out using the pie jaws is five thousandths (0.005 , 0.127 mm)

This pulley has sufficient wall thickness to allow us to use standard soft jaws

Instead, Andrew will use this style of boring ring

As speeds increase over 1000 rpm

I hardly knew what to do.

We set the remaining values conservatively based on the insert we're using to cut these steel jaws

First, we need to choose whether we'll use aluminum or steel jaws

Remember, spindle speed also affects outside diameter holding force

So we set Diameter to Cut to 3.95 inches

Thank you for watching

Kemp! cried the Voice. Kemp!

He tried to raise his head, and encountered an immovable resistance.

And the additional leverage from the longer jaws can overload and damage the chuck

Since the idea is to machine away material to correct the jaw inaccuracies

We need to hold it with internal gripping jaws

Conversely, if Andrew were to machine the jaws at a low stroke position

Today we are joined by Andrew, one of our Haas certified technicians

And in the early automobile, the rear wheels turned separately, and only one wheel was connected to the engine.

In another moment Jaffers, cutting short some statement concerning a warrant, had gripped him by the handless wrist and caught his invisible throat.