Uh, voltage looks fine.

It says, High Voltage. Yeah. Okay. Good.

Stan Can you check the voltage regulator?

what is the optimum voltage for cardiac resuscitation?

I'm going to have to increase the voltage.

Why is there a special high voltage power line?

A phillips screwdriver and a voltage sensing screwdriver or volt meter

little solenoids that will lock it in place and get low voltage power.

And a maximum of 8. 7 Continuous voltage in order to function properly.

Just a small discharge negligible compared to the voltage coursing through that elevator.

I access the drive stun mode, upping the voltage 40 times when directly administered.

Semiconductor is something that's either a conductor or an insulator depending on whether a voltage is applied to it.

It's almost like another generator came online, jacked into the system and overloaded it with double or triple the voltage.

They took the basic ingredients, put them in a single jar and ignited them and put a lot of voltage through.

Use the average of the Phase to Phase voltage measurements just taken and set the Transformer Tap position to match this average number

Use the average of the phase to phase voltage measurements just taken and set the transformer tap position to match this average number

If we double the power with a voltage spike the alarm system, in order to protect itself against an overload, will shut itself down.

If the values are good, make sure the Machine Circuit Breaker is in the OFF position and check that there is no voltage at the Transformer

If the values are good, make sure the machine circuit breaker is in the off position and check that there is no voltage at the transformer

Then, make sure to double check the breaker to ensure there is no voltage present before you swap the positions of the L1 and L2 lines

Make sure to double check at the Breaker to ensure that there is no voltage present before you swap the positions of the L1 and L2 lines

Using a multimeter at the main circuit breaker, check the incoming voltage from phase to phase record each of these values so they can be double checked, later

Well, the doctor can program a level of this ST elevation voltage that will trigger an emergency alarm, vibration like your cell phone, but right by your clavicle bone.

These are concentrating solar, renewable energy plants, linked in a so called supergrid to supply all of the electrical power to Europe, largely from developing countries high voltage DC currents.

Using a Multimeter at the Main Circuit Breaker check the incoming voltage from Phase to Phase noting each of these values so they can be compared to values taken later

And then we put a lead, which is a wire, in the right ventricle inside the heart, which does the electrogram, which is the signal voltage from inside the heart.

no phase to ground value should be larger than any of the phase to phase values a value that is too high likely indicates there is a bad or floating ground in the electrical service to the machine alert the customer what you found if the values are okay, switch the machine's circuit breaker to the off position and check that there is no voltage at the transformer using the average of the phase to phase voltage measurements just taken set the transformer tap position to match this average number

So we made it very small, so things were about 30 nanometers in size making it very cold, so at liquid helium temperatures and changing environment by changing the voltage, and the electrons could make flow around a loop one at a time, on and off, a little memory node.