He's losing his grip.

This graphic illustrates what would happen if you did not cut to the nominal part diameter

She wanted to dance.

He tried to raise his head, and encountered an immovable resistance.

We will address that scenario in another video in this series

We learned about the fundamentals of cutting lathe soft jaws

Not even where the jaw tips contact the work piece

And we'll keep the spindle speed below the recommended 900 rpm

We see a total indicator run out of fifteen thousandths (0.015 , 0.381 mm) at 250 psi

Remember, spindle speed also affects outside diameter holding force

Instead, Andrew will use this style of boring ring

This pulley has sufficient wall thickness to allow us to use standard soft jaws

Which must be completely profiled on the outside face of the part

Since the idea is to machine away material to correct the jaw inaccuracies

Kemp! cried the Voice. Kemp!

Now we're ready to make our part To demonstrate how uniformly the pie jaws grip the part

And the additional leverage from the longer jaws can overload and damage the chuck

We need to hold it with internal gripping jaws

Conversely, if Andrew were to machine the jaws at a low stroke position

In this video, we will demonstrate the proper way to cut OD gripping soft jaws and cover soft jaw fundamentals

So we set Diameter to Cut to 3.95 inches

And in the early automobile, the rear wheels turned separately, and only one wheel was connected to the engine.

The jaw grippers are now facing outward

I hardly knew what to do.

At 250 psi clamp pressure, our part's total indicated run out using the pie jaws is five thousandths (0.005 , 0.127 mm)

Thank you for watching

We set the remaining values conservatively based on the insert we're using to cut these steel jaws

Today we are joined by Andrew, one of our Haas certified technicians

As speeds increase over 1000 rpm

In another moment Jaffers, cutting short some statement concerning a warrant, had gripped him by the handless wrist and caught his invisible throat.

Forward a touch.

Sir... sir...

Make sure you lock up properly.

Fasten your seat belts!

Okay, just be strong, yeah? Okay.

It's just terrible, all this.

Come on!

Check your aim.

Semiquaver.

Someone saw it happen.

Did you have a good time swimming and surfing?

Vicki, Vicki, come on, open your eyes, lookay at me.

Come on, hang in there!

Hang on!

When having friends over for lunch, show them that you really care, by incorporating some fresh flowers in your table scape.