Detorque. Detorque.

When attaching the uncut jaws to the chuck always torque the jaws in place

Torquing angles incoming.

In our case, Andrew will torque the M12 bolts holding these steel jaws to 80 foot pounds

Andrew positions the jaws outwards until the t nuts are near the edge of the chuck body

The high pressure turbine is making about two thirds of the torque that's turning the shaft.

And refer to the chuck documentation for the correct torque value

And if you want to go faster, say on pavement, you can shift to a high gear, and you get less torque, but higher speeds.

Now what's our mantra of this day and age I wonder?

Values

With

Scale

value

Value

Insert

Value

Values

We again have an open list, and we add our state, we write down the g value, but we also write down the g value plus the heuristic value.

Yeah...

Well, that's just positive 2, right?

Then the next line of code I compute the new sum of the g value and the h value.

An integer value with the current status.

Value for DeleteMaximum config entry

So the percentage of variance explained is exactly the same.

This was 0 over here, and it's 1 for these 2 states in red.

Count

Percentile

Gamma

Current Name

F Number

Map values

Numbers

Value

Numeric Value

Numeric value

boolean

Custom value

With value

Y Values

X Values

Substract

Number

F Number

Boolean values

Boolean value