Sort field

Repeat this step until the bubble is adjusted to zero at both ends of the Y axis travel

At the column side, look to see which rear corner of the machine if any, is lowest as shown by the leveling tool

Once the height has been set raise the center leveling screws

Adjustments close to zero will make subsequent changes easier

Move the X and Y axes until the table is centered

lower end of the machine to maintain clearance to the coolant tank

There is a lot of useful information in here

For DS 30 Machines, you will need to Zero each Axis individually after Starting Up

This provides a uniform position to start leveling

Welcome to this How to Level a Haas Lathe video

This reading shows the angle of the machine front to back

Measure from the base casting lower flange and lift the casting four inches (4 or 100mm) off the ground by adjusting the four corner leveling screws to the same height.

The tools need for this procedure are a ratchet and 3 4 socket a 1 1 2 Wrench, Tape Measure and Haas Leveling Tool T 2181

Unite Paths

Flatten Path

Flatten path

Rotate both middle screws up to bring them completely off the middle pads

These adjustments should be very small as we are almost finished

Equalize

Smooth

Smooth

Pacific Time north Yukon

Pacific Time south Yukon

Pacific Time

Adjust the lowest corner up until the leveling tool reads zero

Third, any twist in the Base Casting is removed so the Machine will cut accurately

If the values are different by more than one division then the level should be returned to Haas for adjustment

The middle screws will be seated in this next step and will be used to align the B and Y axes

smooth triangle

On base castings with 6 or 8 leveling screws the middle screws should not be touching the pads during the leveling procedure

First, the Machine is set to the correct height to clear the Coolant Tank

When you, do the simple regression equations.

Lift the right rear corner of the machine until the leveling tool reads zero

Maximize the window horizontally

So the model R squared will not change at all.

Lock the leveling screws in place

It's time for us to get ready too.

Clear Fields

Errors because of twist or bow will cause errors in the spindle tram values

Larger machines with outrigger supports require additional steps during the leveling process

Number to be normalized

Mawhinney expects the NVA appear.

Using only the RlGHT REAR leveling screw make adjustments until the bubble is centered

Equalize