Andrew cuts the taper in the jaws With the taper cut and the work piece clamped at full pressure

No!

Any word from the hydraulic chamber?

The clamping force on the part naturally decreases

Now Andrew uses a slow drying bluing compound to check if he needs to make another slight taper cut

Secondary hydraulic failure.

Show us the hydraulics chamber.

Hydraulic failure. Switching to secondary.

Clamps

To demonstrate a more extreme scenario we move on to these tall 4 inch aluminum jaws

Hydraulics are questionable.

There. Through the hydraulic chamber.

The jaws will deflect away from the part

If he were to use regular soft jaws to hold this thin walled part

Klump, it's me.

Is there another way to the hydraulics chamber?

It's completely submerged down there

They were bored very deep, at a clamping pressure of only 50 psi

I'm going to manual control. Goddamn, boy.

I'll meet them at the hydraulics chamber.

You know, you create power, then you tame it. (Music)

Check the main bus for hydraulics, I'll balance the tanks.

get the clamps ready.

There's something blocking the hydraulics

Something's jamming the hydraulics, Captain.

If your high pressure hose pipe or hydraulic line bulges a little, you just wrap some tape around it, it really is that simple.

He finds a four thousandths of an inch (0.004 , 0.102 mm) space, so he will start by adding a 1 4000 taper to the jaws

And instead of throwing it out, people would think that's a krump move, that's a krump move.

Andrew mounts an indicator to check how much run out we have, with our part gripped in these jaws

Shlubb and Klump were packing an arsenal.

I tell them to create a ball, and then you just use that ball of energy.

The result would be jaws that have very little travel remaining to grip the part, past the nominal diameter

Counter clockwise, to bring the adjustable dowels inward slightly

The difference between

Also denied and eliminated from any further discussion are disc brakes, fuel injection, hydraulic valve lifters, seat belts...

As you look at your setup, visualize the direction you will be clamping in

To do this, unclamp the jaws and rotate the threaded body of the boring ring to adjust the position of the grippers

Oil Paint...

Oil Paint

Oilpaint

Alright. What else?

But sometimes, carbon based organisms like plants or animals get stuck in the earth.

Compression

Pack

Packers