The reason why it eventually comes to stop is because we have the unbalanced force of friction.

Re check both home positions once you have made any adjustments

The calibration process is covered on the Haas Service site

Push the RECOVER button

Use the precision level vial parallel to the turret for this measurement

On a number line, our Total Indicator Reading is three ten thousandths (0.0003 or 0.0076mm) TlR which puts our spindle sweep measurement in specification

On Y axis Machines such as this one the Security Bracket holding the Wedge in place also needs to be removed

It is also possible that the arm is stuck while gripping a tool that is still clamped in the spindle

Jog the turret to the middle of X axis travel

But keep material removal to a minimum, to get the most life out of your jaws

Press LlST PROGRAM and then select the Memory tab

Below the tool offsets are the work zero offsets

Select program O02020 Spindle Warm up and press SELECT PROGRAM

The trick, of course, is to find the nonlinear 1 dimensional space and describe it.

The tool change arm will rotate in reverse and put the tools back into the carousel and spindle

When the coolant tank is full, run each part of the coolant system to check that none of the connections are leaking

delete

Strip

Resume

Remove

Remove All

Delete Key

Remove entry

Downloading remote files

loading previews

Delete the marked selection from the list

Delete selected useractions

Delete files

Selected foreground

Delete foreground

Delete...

Removing

Remove them.

Remove them

Deleting

Trash

Purge

Remove

Delete

Deleted

Spray Object

Deletions

Deletion

Delete it?

However, rapid axis movement is automatically limited to 25 of maximum and the command spindle speed in your program may not exceed 750rpm