Re check both home positions once you have made any adjustments

The calibration process is covered on the Haas Service site

Push the RECOVER button

Use the precision level vial parallel to the turret for this measurement

On a number line, our Total Indicator Reading is three ten thousandths (0.0003 or 0.0076mm) TlR which puts our spindle sweep measurement in specification

It is also possible that the arm is stuck while gripping a tool that is still clamped in the spindle

Jog the turret to the middle of X axis travel

But keep material removal to a minimum, to get the most life out of your jaws

Press LlST PROGRAM and then select the Memory tab

Below the tool offsets are the work zero offsets

Select program O02020 Spindle Warm up and press SELECT PROGRAM

The difference between

Oil Paint...

Oil Paint

Oilpaint

Alright. What else?

The tool change arm will rotate in reverse and put the tools back into the carousel and spindle

When the coolant tank is full, run each part of the coolant system to check that none of the connections are leaking

Hm? What is it?

I need to hurry up and finish so I can practice.

But he's come so far! Very, very charming!

We added in more sugar.

Right.

He's a fuel merchant.

Security is the greatest enemy.

Paint

Oilpaint Filter

Oilpaint filter

You can't just drill a hole and pump it out.

Restaurant food is high in calories.

Make it three. Do not forget the syrup!

Oiled.

No!

You said it was oil futures.

However, rapid axis movement is automatically limited to 25 of maximum and the command spindle speed in your program may not exceed 750rpm

We've stumbled on another energy bonanza in fossil fuels.

Alright?

The source of fuel crude oil.

So lets refuel.

Be on your guard.

Yes, clove oil.

Stay alert.

I don't have to exit this screen to change an offset

Using the older software, this is what we do if the arm is not contacting the tool

The well delivers a great deal of oil.