But keep material removal to a minimum, to get the most life out of your jaws

Re check both home positions once you have made any adjustments

The calibration process is covered on the Haas Service site

Push the RECOVER button

Use the precision level vial parallel to the turret for this measurement

On a number line, our Total Indicator Reading is three ten thousandths (0.0003 or 0.0076mm) TlR which puts our spindle sweep measurement in specification

Holes?

It is also possible that the arm is stuck while gripping a tool that is still clamped in the spindle

Jog the turret to the middle of X axis travel

Press LlST PROGRAM and then select the Memory tab

Mudhole?

Below the tool offsets are the work zero offsets

Select program O02020 Spindle Warm up and press SELECT PROGRAM

Mouse hole

Pitfalls

Prepunched

Number of holes

Number of holes

For holes.

Why?

Straight down, in the hole.

The tool change arm will rotate in reverse and put the tools back into the carousel and spindle

When the coolant tank is full, run each part of the coolant system to check that none of the connections are leaking

Hole radius

The paper said, It's not really balanced.

Gotta be in the ass. Shoot me right there!

It's hollow.

Yes, we have breathing holes.

Watch that fucking hole.

Hello!

It just blew right through the street.

That's right, missy.

Hurry up, asshole!

A sinkhole. Follow me kids!

Dan. A caveman?

A big hole.

Make a hole!

However, rapid axis movement is automatically limited to 25 of maximum and the command spindle speed in your program may not exceed 750rpm

Pot Hole

Time to find out what's so special about it. Sit down, honey.

You'll get your head in a noose.

Jump into that hole.

So... you're a caveman.

Went straight for the hole.

There's Preacher's Cave.