Repeat this step until the bubble is adjusted to zero at both ends of the Y axis travel

Measure from the base casting lower flange and lift the casting four inches (4 or 100mm) off the ground by adjusting the four corner leveling screws to the same height.

At the column side, look to see which rear corner of the machine if any, is lowest as shown by the leveling tool

Move the X and Y axes until the table is centered

Welcome to this How to Level a Haas Lathe video

If the values are different by more than one division then the level should be returned to Haas for adjustment

Smoothed lines

For DS 30 Machines, you will need to Zero each Axis individually after Starting Up

Rotate both middle screws up to bring them completely off the middle pads

There is a lot of useful information in here

These adjustments should be very small as we are almost finished

looks like this. I've organized it a little bit so R won't

This reading shows the angle of the machine front to back

On base castings with 6 or 8 leveling screws the middle screws should not be touching the pads during the leveling procedure

First, we use a technique called dynamic time warping from speech recognition.

(Laughter) And so we've been working on a chassis of the wall itself.

lower end of the machine to maintain clearance to the coolant tank

Make sure the machine is high enough off the ground to clear the coolant tank

And then all of that's being multiplied by 8.

First, the Machine is set to the correct height to clear the Coolant Tank

Next, measure for any bow, either up or down along the length of the Base Casting

We do it voluntarily, and we do it through standardized

There are two models of quality assurance in catering.

It consists of multiplying the values in the first diagonal and subtracting the product of the second diagonal.

This provides a uniform position to start leveling

Larger machines with outrigger supports require additional steps during the leveling process

Once the height has been set raise the center leveling screws

Adjustments close to zero will make subsequent changes easier

The office productivity suite compatible to the open and standardized ODF document format. Supported by The Document Foundation.

Adjust the lowest corner up until the leveling tool reads zero

The tools need for this procedure are a ratchet and 3 4 socket a 1 1 2 Wrench, Tape Measure and Haas Leveling Tool T 2181

Using only the RlGHT REAR leveling screw make adjustments until the bubble is centered

Based on.

With the machine accurately leveled, we move on to checking and adjusting the machine geometrical alignment

Third, any twist in the Base Casting is removed so the Machine will cut accurately

The software will automatically give you.

Lift the right rear corner of the machine until the leveling tool reads zero

Number to be normalized

I've put the unstandardized and the standardized coefficients together in this table so we could get a feel for what they mean.

lift the Base Casting three and a half (3 ½ ) inches off the ground by adjusting the four corner leveling screws to the same height

If there is a big difference then this is a larger value and we know for the day in question what the mean and the standard deviation is for this percentage change.

The reformed Labour Standards Act will be in force from Jan 1st 2004.

Equalize

Smooth

Smooth