If the clamping pressure is set too high in an attempt to increase the clamping force

The clamping force on the part naturally decreases

Also visualize the amount of force you will be clamping with

When clamping force increases so does the deformation of the jaws

At higher holding pressures the ring would begin to distort during clamping

This design allows for slight changes in clamping position to be made easily

The soft jaws are clamping inwards on the boring ring at 100 psi

Particularly at extreme differences in clamping pressure and at very long jaw lengths

With the softer material and different clamping height we might see significant deflection

They were bored very deep, at a clamping pressure of only 50 psi

Attach the Clamping Band outside the Chip Skirt and fashion at the Discharge Port

Using this specific type of grease, clamping force can diminish by 50 or more

As you look at your setup, visualize the direction you will be clamping in

Steel jaws will be used where clamping forces are higher and jaw longevity is important

Instead, refer to your chuck documentation to find a balance between grip center height and clamping force

system

System

System

System

System

In our case we will be clamping the part at 130 psi and the jaws at 100 psi

Right where they need to be to cut these jaws We set the clamping pressure to 100 psi

System Jobs

System Settings

System Testing

system information

System Information

system notification

System Bell

System Font

System colors

System Id

Checking System

System Notifications

System Files

System Theme

System Check

System Cron

System Crontab

System Log

Operating System

System Monitor

System Info

System Notifications

System Bell