Which must be completely profiled on the outside face of the part

We learned about the fundamentals of cutting lathe soft jaws

We set the remaining values conservatively based on the insert we're using to cut these steel jaws

In this video, we will demonstrate the proper way to cut OD gripping soft jaws and cover soft jaw fundamentals

This pulley has sufficient wall thickness to allow us to use standard soft jaws

Since the idea is to machine away material to correct the jaw inaccuracies

He's losing his grip.

Conversely, if Andrew were to machine the jaws at a low stroke position

And we'll keep the spindle speed below the recommended 900 rpm

Where r is the radius of the sphere.

It has a very easy relationship with the radius.

Try to measure a circle.

Aperture

Diameter

Radius

Radius

radius

Radius

We will address that scenario in another video in this series

This graphic illustrates what would happen if you did not cut to the nominal part diameter

Vignetting

Add vignetting

Radius 1

Radius 2

Minor radius

Major radius

MetaBall Radius

Cut off radius

Ionic Radius

Sample radius

Well what's the radius?

A. 45.

We see a total indicator run out of fifteen thousandths (0.015 , 0.381 mm) at 250 psi

She wanted to dance.

So it's essentially two radii.

Now what is the radius?

Hole radius

Cell radius

Maximum radius

Minimum radius

Atom Radius

Bond Radius

Atomic Radius

Deform Radius

Experiment brush