Which must be completely profiled on the outside face of the part

The jaw grippers are now facing outward

He's losing his grip.

And we'll keep the spindle speed below the recommended 900 rpm

We will address that scenario in another video in this series

This graphic illustrates what would happen if you did not cut to the nominal part diameter

We see a total indicator run out of fifteen thousandths (0.015 , 0.381 mm) at 250 psi

She wanted to dance.

We learned about the fundamentals of cutting lathe soft jaws

Now we're ready to make our part To demonstrate how uniformly the pie jaws grip the part

In this video, we will demonstrate the proper way to cut OD gripping soft jaws and cover soft jaw fundamentals

Not even where the jaw tips contact the work piece

At 250 psi clamp pressure, our part's total indicated run out using the pie jaws is five thousandths (0.005 , 0.127 mm)

This pulley has sufficient wall thickness to allow us to use standard soft jaws

Instead, Andrew will use this style of boring ring

As speeds increase over 1000 rpm

I hardly knew what to do.

We set the remaining values conservatively based on the insert we're using to cut these steel jaws

First, we need to choose whether we'll use aluminum or steel jaws

Remember, spindle speed also affects outside diameter holding force

So we set Diameter to Cut to 3.95 inches

Thank you for watching

Octahemioctahedron

Tetrahemihexahedron

What about your mouth?

And I'm going to break it down for you for just a second.

Kemp! cried the Voice. Kemp!

I don't care for lawyers, do you?

you live. mmhm.

He tried to raise his head, and encountered an immovable resistance.

And the additional leverage from the longer jaws can overload and damage the chuck

Since the idea is to machine away material to correct the jaw inaccuracies

But then if it was transparent, we see that there are actually six sides of a cube.

We need to hold it with internal gripping jaws

If I were to just flip this over like this, so we're

Batman may have made the front page but Bruce Wayne got pushed to page eight.

clamp to ground

Front

Back

Plane

Plane

plane

front

back

Jump back